IN THIS DEMONSTRATION WE HAVE USED:
Fiac Silent Air Compressor and 10 way manifold.
1 x Passche H5 single action external mix Airbrushes and 10’ hoses:
1 x Passche 30z plastic bottle and lid assembly: AIRBRUSH BODYART Armband 0028 Airbrush Temporary Tattoo ink colour Black
Medi-swabs: (70% v/v Isopropyl Alcohol Swab) used for cleaning the area of skin
on your customer, where the tattoo will be applied.
Isopropyl Alcohol: used for cleaning stencils, airbrushes and equipment.
Talcum Powder and Powder Brush: used for dusting the finished Tattoo to seal,
dry and protect.
Step 1
Thoroughly
clean the skin with Rubbing Alcohol (70%) and allow skin to dry
Place Stencil firmly in chosen position & try not to move.
Step 2
Now take your
Airbrush
Point the nozzle at your starting point on your stencil Then start to spray.
Careful not to over spray the stencils. (i.e. Outside the stencil) continue
Spraying until the Stencil is finished.
Step 3
Work your way
around the stencil
Step 4
.
Apply an even
coat of Black to the entire stencil area. Spray light coats to ensure even
coverage
Step 5
Keep moving
around the stencil spraying as you go
Step 6
if you have to
move the hand that you are holding the stencil with just rest the tip of
your gun on the stencil while you move the hand that you are holding the
stencil
Step 7
Now you have
come to the end of the spraying check and make shore you have not missed any
of the stencil
Step 8
Now you have
come to the end of the spraying check and make shore you have not missed any
of the stencil
Step 9
Lift off
Stencil careful not to smudge or smear the Wet Tattoo Paint.
Step 10
Inspect the
Airbrush Temporary tattoo to se if there is any overspray
Step 11
Clean up any overspray
Step 12
Dust your
Airbrushed Tattoo with Setting Powder/Talc.
Step 13
Your
Tattoo is complete! Now that couldn't be simpler.
